Destined for the management of domestic aspiration systems, the FEGR031 electronic control system is made up of a power board, capable of driving a 4 speed common wire motor and the lighting system of the hood, and a user interface board featuring 6 capacitive keys with backlight.

The keyboard can be fixed on supports made of glass or Plexiglas of different thicknesses: You can request an appropriate firmware customization to adapt the sensitivity of the touch system to the specific thickness of the used support.

Perfectly integrated into the kitchen, FEGR031 allows the user to access in an easy and intuitive way to various functions implemented and always guarantees, thanks to its efficiency, an optimal level of quality.

This email address is being protected from spambots. You need JavaScript enabled to view it.

 

 

Electronic control system for hoods with capacitive keyboard

 

Technical characteristics of the power board

  • The power board drives a motor 4-speed common wire.

  • Single phase power supply 220-240VAC - 50/60Hz.

  • Maximum power absorbed by the Motor: 400W.

  • Maximum power absorbed by the Lights: 400W.

  • Motor control through relay 7A max. (resistive load).

  • Control the lights through relay 7A max. (resistive load).

  • There are no fuses on the input of the power supply of the board.

  • 10-pin flat link protected with PVC flexible sheath power board and keyboard user interface.

  • Wiring for motor connector 9-pin type MATE-N-LOK TYCO or equivalent, wiring for lights finished with ferrules. NOTE: The network cable is not included because the group takes the voltage from the motor. If the unit is connected to a motor that does not provide the voltage, it is necessary to add to the group a network cable to power the board. On request we can provide the wiring connections and custom lengths.

 

 

tastiera controllore per cappe aspiranti

 

 

Functional and technical specifications of the keyboard user interface

  • 6 keys keyboard with touch + 6 red LEDs.

  • The keyboard can be attached on glass or plexiglass with relative calibration of various thicknesses.

  • An electronic microcontroller control system.

  • Keyboard locking function.

  • Store hours of operation of the hood.

  • Management of the filter and reset the alarm: Filters have a service life of approximately 100 hours of motor operation, past which the DL4 led flashes until reset is performed with the dedicated button SW1.

  • Managing the TIMER function: if this function is activated, the motor stops automatically after 15 minutes.

  • The timer function and fast speed are mutually exclusive.

  • In the event of a momentary power failure, the hood back on stand-by, is not restored the previous operation.